The Smith Enterprise Tactical Cheek Piece Completes a Scoped Rifle
Which of the following can happen when you mount a scope on a rifle primarily designed for iron sights?
A. It becomes more dangerous-er, and therefore illegal in New York, Colorado and within 500 feet of banks located on the Island of Cypress.
B. Your primary self-defense plan becomes shooting the gun out of the bad guy’s hand. From 600 yards away.
C. The effective range of your rifle increases 5,432%, allowing you to easily hit targets up to 17.2 miles away.
D. The scope is a lot higher than the iron sights and you have to stretch your neck like a Gumby action figure to see through the scope.
If you answered (B) perhaps you should take up macrame instead of shooting? If you answered (D) you are correct!
For Part 2 of our Springfield Armory M1A Standard rifle project, we mounted a scope to the M1A using a Springfield Armory steel scope base. Once mounted on top of the M1A receiver, the rail itself is already higher than the iron sight plane. Add rings and a scope and now the scope sighting plane is roughly an inch and a half taller than the iron sight plane. The walnut stock on this rifle is not adjustable, so unless you can extend your jaw an extra inch or so on command, you’ll find that attaining a firm cheek weld and being able to see through the scope are somewhat mutually exclusive. Accuracy really suffers when trying to hover your face a couple of inches above the stock.
Here’s where a cheek piece comes in handy. There are all sorts of cheek piece solutions. Some of our most decorated snipers in the Vietnam war attached shaped blocks of wood to the top of their rifle stocks. You can do that too. Or you can acquire an elastic slip-on pad with foam inserts to add some height to your stock. We’ve tried those, and while they are inexpensive and simple solutions, they aren’t all that great. Things just move around too much and the foam insert pads can be too squishy, preventing you from getting a solid and repeatable position on the stock.
A number of vendors make cheek rests that strap on with velcro, straps or cords. Many of these have either padding or a firm insert that increases height of the stock. The Smith Enterprise model uses three straps that go around the bottom of the stock and a fourth that wraps around the butt of the stock.
The exterior of the Smith Enterprise Tactical Cheek Piece is a solid canvas material. The insert is very firm, with just a little bit of give. This achieves two goals: getting a solid and repeatable position on the gun and providing a bit of recoil dampening for your jaw bone. The insert is just about 1 ½ inches high, so it creates perfect scope alignment on the M1A shown in the photos here. The interior of the rest is made of a rubberized material so it grips the stock really well.
Once we got this mounted on the Springfield Armory M1A Standard rifle with walnut stock, it didn’t move around. At all. As you can see by the photos, we mounted this with all three straps forward of the sling loop on the bottom of the buttstock. You may prefer to mount it so that the third strap is behind the sling loop to help prevent forward / backward motion. We just liked the fit as shown, and with the fourth back strap, we did not have any issues with the pad moving.
While this specific model is marketed as a solution for the M14 / M1A rifle, it will fit most any rifle with a more or less standard stock. If you need about an inch and a half of height, check out the Smith Enterprise Tactical Cheek Piece. It’s a solid and well made product.
|Four Nuns! The rubberized backing and vertical horizontal strap system ensure that this stays solid in place through carry and recoil. We also really liked the firmness of the cheek insert. It’s solid enough for a good cheek weld, but still offers just a bit of cushion.|
|Available Here||Smith Enterprise Tactical Cheek Piece|